TI: GaN power design drives 200-V AC servo drives and robotics with 99-percent efficiency

Texas Instruments introduced an innovative three-phase, gallium nitride based inverter reference design that helps engineers build 200-V, 2-kW AC servo motor drives and next-generation industrial robotics with fast current-loop control, higher efficiency, more accurate speed, and torque control. Download the reference design today.

The Three-Phase High-Frequency GaN Inverter Reference Design features TI’s newest LMG3410 600-V, 12-A GaN power module with an integrated FET, gate driver and protection, announced last year. The GaN module allows the design to switch up to 5x faster than silicon FETs, while achieving efficiency levels greater than 98 percent at 100 kHz and greater than 99 percent at 24 kHz pulse width modulation (PWM) frequency. With GaN, designers can optimize switch performance to reduce power loss in the motor, and downsize the heat sink to save board space. Operating the inverter at 100 kHz significantly helps improve torque ripple when used with low-inductance motors.

The GaN inverter power stage easily interfaces with microcontrollers, including TI’s TMS320F28379D drive control system-on-chip to help dynamically adjust voltage frequency and achieve ultra-fast current loop control. TI also introduced today its new DesignDRIVE Fast Current Loop software with innovative sub-cycle PWM update techniques that help push current-loop performance in servo drives to less than 1 microsecond, potentially tripling motor torque response. The Fast Current Loop software outperforms traditional MCU-based current-loop solutions, and is available free with controlSUITE software.

In addition to the GaN module, the reference design relies on TI’s AMC1306 isolated delta-sigma modulators with current sensing to increase motor control performance. TI’s ISO7831 digital isolator also provides reinforced isolation between the MCU and the design’s six PWMs.

More Information...

Latest News from

TI: GaN power design drives 200-V AC servo drives and robotics with 99-percent efficiency
TI: DesignDRIVE software for C2000 MCUs helps achieve sub-1 microsecond current loop
TI: SoCs drive down cost of multi-protocol industrial Ethernet communication
TI: small gate driver and power MOSFET solution for motor control
TI: reinforced isolator with integrated power
TI: SimpleLink platform transforms development with 100 percent code reuse
TI: 4-20mA DAC with integrated buck/boost converter
TI: tiny 12-V, 10-A DC/DC step-down power solution

ZES Zimmer on testing advanced power electronics

In this video Bernd Neuner from ZES Zimmer talks to Alix Paultre for Electronic News TV at the 2017 Power Electronics Conference in Nuremberg. The discussion deals with the issues involving test and m...

Weidmüller discusses the need for a better signal and power interface

In this video Rene Arntzen from Weidmüller talks to Alix Paultre of Electronic News TV about the importance of a good signal and power interface for industrial equipment. There is currently no good ...

Mouser talks about the state of engineering development today

In this video Mark Burr-Lonnon and Graham Maggs of Mouser Electronics, a major international electronics distributor, talk to Alix Paultre about the state of engineering development today. With massiv...

Infineon launches a new family of configurable industrial drive boards

In this video Infineon explains their new family of configurable industrial drive boards at SPS-IPC Drives 2017. Intended to enable easy setup and deployment, the XMC-based automation boards can handl...

STMicro explains their STSPIN family of single-chip motor drivers

In this video STMicroelectronics explains their STSPIN single-chip motor drivers at SPS-IPC Drives 2017. The STSPIN family embeds can drive motors efficiently and with high accuracy, with an advanced ...