Rohde & Schwarz presents test solution for 3GPP release 14 location services for NB-IoT

Rohde & Schwarz and CommSolid have successfully completed the verification of 3GPP Release 14 location services (LCS), which is one of the new positioning technologies for NarrowBand-IoT (NB-IoT). The Cat-NB2 verification was performed with CommSolid's NB-IoT modem solution against the R&S CMW500 mobile communication tester. The R&S Location Based Services (LBS) solution based on R&S CMWcards GUI, a subset of TS-LBS, allows the verification of chipsets and mobile devices for mobile manufacturers, chipset manufacturers, test houses and network operators with the target to get permission to operate them in a particular network.

The successful NB-IoT location services verification of the CommSolid NB-IoT modem using the Rohde & Schwarz test solution marks an important milestone in IoT positioning and navigation. The R&S CMW500 mobile communication tester equipped with the R&S CMWcards LBS solution and the CommSolid NB-IoT modem form the first test platform to offer verification of Cat-NB2 location services.

R&S CMWcards supports location-based services testing of 3GPP Release-14 NB-IoT devices. The software runs on a R&S CMW500 which acts as a base station simulator for several cells. The device under test (DUT) observes the time difference of arrival (OTDOA) of the simulated cells and reports it to the serving cell, which is also simulated by the R&S CMW500. The R&S CMW500 calculates the position of the DUT by using the reported OTDOA measurements and sends the position coordinates back to the DUT. This R&S LBS solution based on R&S CMWcards is able to provide R&D as well as GCF and PTCRB pre-certification for chip sets and mobile devices.

At MWC 2018, Rohde & Schwarz will showcase this first test solution for Cat-NB2 LBS based on the R&S CMW500 with R&S CMWcards and CommSolid's NB-IoT modem.

More Information...

Latest News from Rohde & Schwarz GmbH & Co. KG

Rohde & Schwarz: new signal generators set standards in the class up to 6 GHz
Rohde & Schwarz: RTP family combines innovative signal integrity with high acquisition rate
Rohde & Schwarz presents innovative test and measurement equipment
Rohde & Schwarz: FPC entry-level spectrum analyzer combines three key RF test instruments
Rohde & Schwarz to present signaling test solution for Bluetooth LE
Rohde & Schwarz: signal generation and analysis solution for 5G New Radio at MWC 2018
Rohde & Schwarz presents test solution for 3GPP release 14 location services for NB-IoT
Rohde & Schwarz: T&M tools to minimize multi-region drive tests for LTE modules
Rohde & Schwarz: test solutions for Broadcom 802.11ax Wi-Fi devices
Rohde & Schwarz: moveable over-the-air test chamber for 5G antennas and transceivers
Rohde & Schwarz: EMC test and measurement solutions at EMV 2018
Rohde & Schwarz: WLAN signaling tester to emulate all IEEE 802.11a/b/g/n/ac standards
Rohde & Schwarz presents deep packet inspection engine at Embedded World
Rohde & Schwarz increases bandwidth of power rail probes to 4 GHz
Rohde & Schwarz: innovative T&M equipment for next generation designs at embedded world
Rohde & Schwarz: RTC1000 oscilloscopes offer eight-in-one instrument integration
Rohde & Schwarz: new embedded oscilloscope family with 10-bit vertical resolution
Rohde & Schwarz: vector signal generator achieves up to 1 Mpulse/s
Rohde & Schwarz supports ESA JUICE expedition
Rohde & Schwarz Cybersecurity and Radisys partner on networking and security solution

Dirk Giesen describes the Parasoft tool suite for Embedded Software Development

Are you responsible for embedded software development in your organization? Your goal should be to create safe, secure, and reliable software. To make sure your device will work properly, deploy Paras...


Ross Sabolik of Silicon Labs talks about advanced Power over Ethernet

In this video Ross Sabolik of Silicon Labs talks about smart  Power over Ethernet systems with Alix Paultre at their APEC exhibit in San ANtonio, Texas. As PoE migrates to higher power levels and...


Dialog Semi walks through their latest IC solutions for battery chargers

In this video an engineer from Dialog Semiconductor walks us through their latest ICs for battery chargers at APEC 2018. Dialog's Qualcomm Quick Charge adapter solutions offer high efficiency to e...


Steve Allen of pSemi explains their latest LED driver solution

Steve Allen of pSemi explains their latest LED boost product based on Arctic Sand's two-stage architecture. Their PE23300 has a charge-pump, switched-capacitor architecture that offloads most of t...


Teledyne describes their latest 12-bit Wavepro HD oscilloscope

In this video Teledyne LeCroy describes their latest Wavepro HD oscilloscope to Alix Paultre of Power Electronics News at the company's launch event. The WavePro HD high-definition oscilloscope de...


Dialog Semi walks through their latest IC solutions for battery chargers

In this video an engineer from Dialog Semiconductor walks us through their latest ICs for battery chargers at APEC 2018. Dialog's Qualcomm Quick Charge adapter solutions offer high efficiency to e...


ROHM explains their latest wireless battery charger solution kit

In this video an engineer from ROHM goes over their latest wireless power development kit, co-developed with Würth for embedded development. The kit provides a complete wireless power transfer sy...


Tektronix describes their latest mixed-signal oscilloscope

In this video Tektronix explains the features in their latest 5 Series MSO Mixed Signal Oscilloscope. Features include an innovative pinch-swipe-zoom touchscreen user interface, a large high-definitio...


AVX shows a supercapacitor demonstrator at APEC

In this video Eric from AVX explains their supercapacitor demonstrator box at APEC 2018 in San Antonio, Texas. The box shows how a 5V 2.5-farad supercapacitor can quickly charge up using harvested ene...


OnSemi explains their latest passive smart wireless sensor for industrial applications

In this video On Semiconductor explains their latest wireless sensor for hazardous environments at APEC in San Antonio, Texas. Intended for applications like high-voltage power cabinets and other plac...


TI demonstrates an improved gaming power system at Embedded World

In this video Texas Instruments' explains Significant reduction in ripple, which results in improved reliability and increased design margins, among other advantages. Another benefit that improve...


Infineon explains their latest motor drive technology at APEC 2018

In this video Infineon demonstrates new gate drivers using their LS-SOI technology at APEC 2018. In the demo Victorus, an Infineon application engineer, shows in real time how much better thermal the ...


STMicro goes over their latest wireless-enabled microcontroller for the IoT

In this video STMicroelectronics goes over their latest wireless-enabled STM32WB microcontroller for the IoT and intelligent devices in several live connectivity demonstrations at Embedded World 2018....


wholesale jerseys